Were changes made to 1.0.2?

jtpryan · Post by **jtpryan** » 2006-12-12 16:02

Last night I uninstalled Ultravnc from my home system. I then installed 1.0.2. Now I can't get sombody to connect to me using my SC executable. This person connected fine before I upgraded. They launch the SC app and my listener never sees it. Essentially nothing happens on my end.

Before I go through a lot of debugging I just wanted to be sure there was not some change in this build that could have changed this.

Thanks,

-Jim

bevtech · Post by **bevtech** » 2006-12-13 00:57

I think the only major change is in the winvnc.exe. ( Hoping a Developer can confirm)

By chance did you have different port then the default??

If so, make sure that you change the listening port

Also make sure that your Wan Ip didnt change. Sometimes I have seen dynamic DNS not update so make sure that it still has the correct address if that applies to your situation..

dsmit26 · Post by **dsmit26** » 2006-12-19 21:20

I ran into the same issue. If you are using the newest VNCserver, you need to use the newest viewer to access the server.

tonyp001 · Post by **tonyp001** » 2006-12-28 23:52

I seem to be having a similar issue except I started w/version 1.0.2.
I configured everything correctly (listening ports, forwarding, etc), but nothing happens on my end (the viewer side). Any ideas?

UltraVNC

Were changes made to 1.0.2?

Were changes made to 1.0.2?

Re: Were changes made to 1.0.2?

Re: Were changes made to 1.0.2?

Re: Were changes made to 1.0.2?