New Version

[alforreca]

Hi,

I installed the new version. Congratulations would be wonderful to have good quality support software free.
Worked fine but... Might be a strange question?
Is it possible to run the server part in private own dedicated server? With static public ip and all the nat done?
I tested the viewer with default settings... so it logins to you may group and server ip. Shows a bunch of "people there"
Not much info about V2.... the old version we could use the repeater to act as intermediary.
I'm clueless about V2... is this possible, run my own server/group/slave servers?
any small how-to available?

BR
Al

[transambird_2000]

The new version has an access server that replaces the repeater. The access server is available on the same page as the other files.

EDIT: I lied, it's not on the main page yet. There is a link in the post below. It's the 3rd party piece.
https://forum.ultravnc.net/viewtopic.php?f=65&t=29336

[alforreca]

Thanks.
Will give it a go and post back.
When do you predict the new version release?

[alforreca]

I tested the software.
ufffff really complicated.

I installed access server over wan
from my lan I can connect the viewer over wan
form my wan lan I can connect the viewer also

I installed 1 SC server in my lan
I installed 1 Sc server on the wan lan

none of the slave server are showing in any of the viewers?

[transambird_2000]

I haven't had any time to test this stuff. I am in the middle of a big project. I am sure as time progresses it will work better. We used a paid for client that was really similiar to this called impcremote. It had a very similiar "manager". I am sure it will work.

[KyferEz]

I can't get it to connect.
I set the group name
I set the password
I setup an SC and transferred to another PC.
I run the SC and it says connecting...
On the Viewer I see the ID I created, but the icon is orange.
If I right-click the ID and click Setup P2P it flashes for a bit and the goes back to orange.

I've tried with multiple PCs on different networks

[Rudi De Vos]

Perhaps the server password wasn't set on the viewer.
Click the icon ID on the viewer and set password.

The viewer also allow to set a save password, this is only use the protect the viewer settings,
it has nothing to to with the server<->viewer passwd.