Single Click without form

aferreirag · Post by **aferreirag** » 2011-09-17 19:05

Hi,

Excuse my bad English.

You can create a SC.EXE File without displaying the Connection form ?

For example:

MySC.EXE MyIPAddress:PORT etc....

The idea is to run the SC and that connects to an IP automatically without asking the end user.

Is It posible?

Thanks for the help they can provide,
Angel Ferreira.

B · Post by B » 2011-09-18 02:33

Yes, that's what the [DIRECT] parameter does. See http://www.uvnc.com/pchelpware/sc/helpdesk.html

aferreirag · Post by **aferreirag** » 2011-09-18 05:36

Hi,

Thanks for your reply!!!!

Add the [DIRECT] parameters to my helpdesk.txt file and really works.

This is great !!!!!!

Still, the connection form, appears about 2 seconds.

There is no way to avoid this behavior?

Thanks again

B · Post by B » 2011-09-19 15:00

I'm not sure; I remember some people talking about that behavior in the last couple of months -- you could read through the forum. As of 2008 it sounds as if one needed 3rd party add-ons -- https://forum.ultravnc.net/viewtopic.php?f=15&t=12404

But some of us use different "SC" style spinoffs instead, including SCPrompt and ChunkVNC.

YY · Post by YY » 2011-09-19 16:30

aferreirag wrote:Still, the connection form, appears about 2 seconds.

There is no way to avoid this behavior?

The SC itself doesn't provide an option to avoid this.

I had worked this out by patching the SC.exe, so that it didn't show the GUI

aferreirag · Post by **aferreirag** » 2011-09-20 04:15

Thanks for replay!

I read the post recommended by "B" and I tell them.

Thanks again!

Regards,
AF

UltraVNC

Single Click without form

Single Click without form

Re: Single Click without form

Re: Single Click without form

Re: Single Click without form

Re: Single Click without form

Re: Single Click without form