-run and -connect on the same command line.

Claudio Roberto Cussuol · Post by **Claudio Roberto Cussuol** » 2005-01-18 13:55

I've wrote a little wizard to help my clients get remote support using ultr@vnc.

I'd really like to be possible to run the winvnc server and then tell it to call my help desk.

I know i can to use winvnc -run and then winvnc -connect my.ip.number::my.port but I'm having some problem to syncronize this 2 commands because I don't know how many time winvnc will take to start on my clients computers.

Josh · Post by **Josh** » 2005-01-25 13:54

I'd like to have this too.

UltraVNC Fan · Post by **UltraVNC Fan** » 2005-01-31 01:58

I would REALLY like to see this too. It would become the defacto standard for remote support if this feature was implemented. Right now there are commercial products that charge big $$$ for this feature and all they are doing is customizing UltraVNC.

Guest · Post by **Guest** » 2005-01-31 02:48

Why not just use SC?

Claudio Roberto Cussuol · Post by **Claudio Roberto Cussuol** » 2005-02-03 23:01

Excuse me but what is SC?

Claudio Roberto Cussuol · Post by **Claudio Roberto Cussuol** » 2005-02-03 23:10

Excuse again.
I've found Single Click and it is exactly what i need.

Thank you very much.

-run and -connect on the same command line.

-run and -connect on the same command line.

This is a biggy