3 monitor functionality not working

[dh10]

We just transitioned from 1.0.0.0 to the 1.0.8.0 and have noticed how the multiple monitor interface has changed.

In the older version, vnc simply scrolled across all screens. So single, dual, and even triple screens were easily viewable by simply scrolling left to right.

The new version has the button to swap to the other screen, which is fine. The only problem is the three screen setup only lets me switch to two of the screens. in fact, it only provides viewing for the left and right screen. The middle screen is set as the primary. So I can not even see the primary screen.

Any ideas on how to address that?

thanks

[Rudi De Vos]

Like in 1.000 the mirror driver need to be installed to get the view all function.

The swap button -> prim/secondary/all , but all only works in combination
with the mirror driver.

[dh10]

Perhaps I am not doing the mirror driver correctly. I am running the driver install, but how can I confirm it is there?

[redge]

dh10
folder UltraVNC\driver\
old mirror driver...
uninstall_silent.bat the old driver with admin right w2k/xp
(uninstall_silent.bat with run as administrator on vista/7)

reboot required
go to \UltraVNC\driver\ the go to folder of corresponding OS w2k, xp or vista
install_silent.bat the new driver with admin right w2k/xp
(install_silent.bat with run as administrator on vista/7)