Trouble using SC in Windows 7

[ThorCarlson]

Referencing the post at
[post=58493][/post]
"What I did to get Windows 7 working 100% on latest VNC"

Both viewer and server are working well in windows 7, but I'm having trouble getting SC to work.
I've got this PC dual booted with Vista Ultimate and Windows 7 Ultimate, same static internal IP address (192.168.2.200).
I've got the same helpdesk.txt file and executable.
I've got the router (Belkin) correctly configured to forward the port.

SC is working well in Vista but I can't get it to work in Windows 7 (same PC, different boot).
I've turned off the Windows firewall, no other firewalls are running on the machine.
I can launch the VNC server on the windows 7 machine and connect easily to windows 7 from a remote XP PC.
When I launch vncviewer -listen 5500, that's when I can't get in.
vncviewer shows up in taskbar, and says it's listening on port 5500, but I can't connect using my compiled SC executable, essentially, nothing happens, and I see no error messages.

Again, works fine on same PC with same IP when PC is booted into Vista, just not in Windows 7.
Any troubleshooting ideas?

[fangthorn]

Two things come to mind.
1. Check your router logs they may give you a clue as to whats going wrong.
2. Try using a different config file for W7. i.e. set W7 to a different ip address and port. and create a new rule on your router for these settings.

If you don't want to do this then try removing the vista settings from your router's, just leaving the W7 settings.

[redge]

i tested SC based 27.08.2009 successfully
[topic=15865][/topic]

SC on win7rc 32bit to win7rc 32bit vncviewer -listen (1.0.6.4 )
no problem

except on computer where running sc while connection is terminated
This program might not have installed correctly like happen to ssx4life
Rudi wrote is the 7-zip self-extractor used in SC but i can't update/veryify since i won't have offline compiler and forget all the required file for do it offline.

[OPERATOR]

i have exactly the same problem, if i start the viewer, i don’t get any message about a incoming call. The viewer don’t give a menu after the first call and must be terminated on windows 7 x64 ultimate. I made the SC with this maschine too and it don’t open a port to the remote pc. Only if I build everything on another OP it works.

[redge]

the actual SC for vista/7 is 32bit !!!!!
that maybe the cause of users of vista but won't tell their have the 64bit version of the OS except OPERATOR