Ultra VNC SC Frustration

[venom]

While the uVNC SC setup docs seem to be ok, what am I supposed to setup on the sender side?

I have created a custom SC executable with my external IP.
I have port 5500 forwarded to my statically assigned workstation here.
When I start the SC on the client I sent the executable to it instantly fails.

Am I supposed to run the Viewer or Server on MY end as well? There are zero instructions on this and one cannot assume someone is very familiar with UVNC.

Thanks for any suggestions on what to do.

[venom]

Here is my config file as there may be a problem there too. IP is bogus.

[TITLE]
Remote Test

[HOST]
Internet support
-connect 123.123.123.123:5500 -noregistry

[HOST]


[TEXTTOP]
Double Click HERE to initiate remote support.

[TEXTMIDDLE]
Before making a connection

[TEXTBOTTOM]
Please Call Support @ Phone

[TEXTRBOTTOM]


[TEXTRMIDDLE]
Support

[TEXTRTOP]
Remote Support

[TEXTBUTTON]
More Info

[WEBPAGE]
My website

[TEXTCLOSEBUTTON]
STOP test


[BALLOON1TITLE]
Establishing connection ...

[BALLOON1A]
5 min try period

[BALLOON1B]
If it fails, the software will remove himself

[BALLOON1C]
from your system.

[BALLOON2TITLE]
Connection active.

[BALLOON2A]
Warning, your desktop is remote visable

[BALLOON2B]
You can break the connection any time

[BALLOON2C]
by using the close button

[WEBPAGE]
http://www.ultravnc.net

[venom]

I figured it out finally.

You must go to your UVNC Programs folder and run the uVNC Viewer in Listen Mode. For my case, i chose the one without Encryption and it worked just fine.

Hope this helps someone.