The viewer does not seem to close the connection correct when it has not been connected to a server. E.g. click on start and then stop without having had a server connection.
The problem is that the Linux repeater does not detect that the viewer has disconnected.
The same scenario works fine with the server connecting and disconnecting without having had a viewer connection.
Update: UltraVNC 1.4.3.6 and UltraVNC SC 1.4.3.6: https://forum.uvnc.com/viewtopic.php?t=37885
Important: Please update to latest version before to create a reply, a topic or an issue: https://forum.uvnc.com/viewtopic.php?t=37864
Join us on social networks and share our announcements:
- Website: https://uvnc.com/
- GitHub: https://github.com/ultravnc
- Mastodon: https://mastodon.social/@ultravnc
- Facebook: https://www.facebook.com/ultravnc1
- X/Twitter: https://x.com/ultravnc1
- Reddit community: https://www.reddit.com/r/ultravnc
- OpenHub: https://openhub.net/p/ultravnc
Important: Please update to latest version before to create a reply, a topic or an issue: https://forum.uvnc.com/viewtopic.php?t=37864
Join us on social networks and share our announcements:
- Website: https://uvnc.com/
- GitHub: https://github.com/ultravnc
- Mastodon: https://mastodon.social/@ultravnc
- Facebook: https://www.facebook.com/ultravnc1
- X/Twitter: https://x.com/ultravnc1
- Reddit community: https://www.reddit.com/r/ultravnc
- OpenHub: https://openhub.net/p/ultravnc
Viewer does not close connection correct
Re: Viewer does not close connection correct
After some tests I have discovered that the viewer not disconnect correct before after 300 seconds (viewer idle timeout).
Last edited by olest on 2008-04-17 18:18, edited 1 time in total.
Re: Viewer does not close connection correct
If I toggle debug I get the following at disconnect:
Socket error read, error code 10004
A blocking operation was interrupted by a call to WSACancelBlockingCall
But only with the linux repeater i think.
Socket error read, error code 10004
A blocking operation was interrupted by a call to WSACancelBlockingCall
But only with the linux repeater i think.