Mappng fails

[dwils]

New at this--any help greatly appreciated. Test mapping always fails. Cannot get connection to person I'm trying to help. Sent the server to him--he runs, but connection fails

[bevtech]

did you try the zero configuration that is stickied on this subtopic??

Sounds like you dont have the ports open for the program to work

[dwils]

tried it with no success--he keeps getting "fails to connect" as I do on my end.

[bevtech]

what id are you using??

[dwils]

id is 51949--question--how does the server know what I/P to connect to--it's not obvious to me?

[bevtech]

You are not even listed in the repeater01 are you sure you are following the zero configuration and having a successful test??

[dwils]

not sure of anything--will give it another try--thanks

[bevtech]

the viewer and server each have had the id assigned to them. Then the data is encrypted and sent via the repeater to both parts.


need to fill out a name for your connection
need to put a password in then the information form the zero config

save the settings once they are saved then you must create the server

the server is saved under a file in myservers folder

send that file to the machine you want to remote control..

[dwils]

still :unable to map"

Alias:Repeater DW
Password: ****
ID: 1949
Host Repeater: Repeater01.unvc.info
Listen Port Viewer: 5901
Listen Port Server: 5900
Auto Map: unchecked



[mod=3406,1188942555] removed password and the /list on the post [/mod]

[bevtech]

choose repeater

ID: 1949
Host Repeater: Repeater01.unvc.info
Listen Port Viewer: 5901
Listen Port Server: 5900 <<<<<<<5500 <b> change this </b>
automapped unchecked


save the settings create the the server

choose test see if it works

[dwils]

at last---thank you thank you--finally got:Viewer Port OK, Server Port OK--now to get the server to my friend and test. Thanks again.

[bevtech]

you are welcome hope it works for you..