lookg for path /program files/ultravnc after compile vnc-sc

TKD · Post by **TKD** » 2006-12-25 02:00

Hi

Can you tell us where in the source to look for the code to change so that vnc-sc does not look for the rc4.key when SC is run?

we can't seem to find it so that we can change the path to look elsewhere for the rc4.key.

THANKS!

redge · Post by **redge** » 2006-12-25 02:14

as my knowledge, is hard coded, not custom.
UltraSam work for the main UltraVNC for allow variable for path of dsmplugin and key, then I think no update for SC because is replaced by pchelpware
maybe another staff could continue SingleClick VNC compatible with the most update of UltraVNC.

TKD · Post by **TKD** » 2006-12-26 19:12

just to be clear: so the /program files/ultravnc path is hardcoded in the source somewhere??

please let me know...and can you say where?

thanks for your time!

UltraVNC

lookg for path /program files/ultravnc after compile vnc-sc

lookg for path /program files/ultravnc after compile vnc-sc

Re: lookg for path /program files/ultravnc after compile vnc

Re: lookg for path /program files/ultravnc after compile vnc