How to change listening port of vnc listening mode

[countdown]

How to change listening port of vnc listening mode
thanks

Excuse my english i am french

[bevtech]

Do you mean in Single Click or in a standard viewer??

Do you use a repeater??

Do you use ID's

Redge wrote this in another posts:


# 1st solution

[HOST]
pc0
-connect 192.168.1.100::5500 -noregistry

[HOST]
pc1
-connect 192.168.1.101::5501 -noregistry

[HOST]
pc2
-connect 192.168.1.102::5502 -noregistry

NAT router config
pc0 external 5500 --> internal 192.168.1.100 port 5500
pc1 external 5501 --> internal 192.168.1.101 port 5501
pc2 external 5502 --> internal 192.168.1.102 port 5502


and your vncviewer -listen port
Start... Run...
pc0 "%programfiles%\UltraVNC\vncviewer.exe" -listen 5500
pc1 "%programfiles%\UltraVNC\vncviewer.exe" -listen 5501
pc2 "%programfiles%\UltraVNC\vncviewer.exe" -listen 5502


# 2nd solution for viewers

[HOST]
pc0
-connect 192.168.1.100::5500 -noregistry

[HOST]
pc1
-connect 192.168.1.101::5501 -noregistry

[HOST]
pc2
-connect 192.168.1.102::5502 -noregistry

Hope this answers your question.

[icon58]

Hello:
Different person same question??? It seems that the reply you gave was for SC but not the listening viewer. I bring up the listening viewer and cannot find a place to change what port it is listening to IE 5001, 5002 etc.
Thank you Icon58

[Jcopeland]

to get your viewer to listen on different ports just do the following:

right click on the viewer icon on your desktop or startment - where ever you put it - and choose properties. In the target field you will see at the very end "-listen" add your desierd port after that. Example is if you want to listen on 5690 it should read "-listen 5690" without ".

close the tray icon and reopen and there you go.