Command line -connect ID option

[DavideCapod]

Hello, I would like to specify the ID option for the reverse -connect option to allow one-click connection using repeater.
When this will be possible?
I already posted this some time ago without aswers...

Thanks
Davide

[Southern]

I am looking for this function for long time too.

[redge]

now available

vncviewer + SingleClick command line connect to repeater mode II
[topic=3173][/topic]

[Sam]

I am a little confused about this. Somethings I am concerned about are:

1) Can you change the -id on the fly in single click so you dont' have to create so many files if you put this on many computers? If so, does it still work when you use [DIRECT]?

2) Can you schedule SingleClick to run so often, or to always remain open so that a client doesnt' need to start SingleClick?

3) Can SingleClick successfully connect to a repeater?

4) Is it possible to close and restart single click so often so it works seamlessly?

Thanks

[redge]

1)
no, -id, you need only one repeater

yes, id_number can be changed every time you start SC, you need to use and put [ENTERCODE]
SingleClick show entercode and customer need to put an new id number that you give to your customer by phone, e-mail, instant messenger, sms, etc...

2) you need Remote Support System is a optimized SingleClick by cheaha
[topic=3387][/topic]

3) yes sure

4) yes

you welcome

[shrefler]

I have a couple problems still...

1) Is there a way to disable the startup flash screen when using [DIRECT]

2) I'd like to run SC as a scheduled task so that i could specify an -id rather than prompting the user

Thank you

[redge]

1), not yet, maybe one day, only any dev can know and update it.

2) don't include [ENTERCODE] and there no prompt and only one id_number is accepted.
There only show startup flash screen

remember:
-id id: The id used for repeater connection, -connect is in that case the repeater ip port

[rsearcy]

So is there not a way to do a "Add new Client" to a repeater on a server from the command line?