MS Logon issues. Not saving settings correctly

boscotherock · Post by **boscotherock** » 2023-10-25 16:48

Was just curious to see if anyone could help. Trying to configure MS logon settings and set the domain group that we allow access to connect. I remove all the pre-filled group names and enter in the one that we use, save and close the admin properties. When I go back into admin properties it reverted to the pre-filled group names and my changes are gone. I'm not sure where it is pulling this info from because if I check the ultravnc.ini file in Program Files, it is showing my changes, but not using them for some reason.

We do use software that restricts privileged access and file access, but for this test I've made this computer exempt from all restrictions. There should be nothing holding it back from saving and using the settings. I just can't seem to find where it is pulling these group names from when then INI shows my changes correctly.

boscotherock · Post by **boscotherock** » 2023-10-25 18:01

So more findings, i've been trying other past versions of uvnc and it seems like every version of 1.4 has this issue but when I install the last release of 1.3 then everything works as intended. Not quite sure what is going on with that...

Post by **Rudi De Vos** » 2023-10-26 17:45

could repeat it

Post by **Rudi De Vos** » 2023-10-26 18:31

found
If you set defaults after loading the ini, it never get used

Post by **Rudi De Vos** » 2023-10-26 18:50

Update that fix this
https://uvnc.eu/download/1437

UltraVNC

MS Logon issues. Not saving settings correctly

MS Logon issues. Not saving settings correctly

Re: MS Logon issues. Not saving settings correctly

Re: MS Logon issues. Not saving settings correctly

Re: MS Logon issues. Not saving settings correctly

Re: MS Logon issues. Not saving settings correctly