Enabling File Xfer Mode on SC

Doofur · Post by **Doofur** » 2005-01-17 21:02

To enable File Xfer, do I need to add the zip/unzip .dll's to the archive before I upload it?

Post by **Rudi De Vos** » 2005-01-17 22:42

FT is only possible for Single files....
Directory transfer and SC does not work. You always can zip them manual.

Viewer RC19_4 is required to use FT.

Doofur · Post by **Doofur** » 2005-01-17 22:54

Thanks for your support!

Rudi,

If you're interested and would provide a valid email address, I will send you my one click setup. It will install on Windows based PC's regardless of permissions and has auto-connect capability on reboot.

Post by **Rudi De Vos** » 2005-01-18 23:08

Always interested in in setups or code....

rudiDOTdeDOTvos@skynetDOTbe

Replace DOT by .

Post by **ipsec** » 2005-01-19 03:17

Doofur wrote:Thanks for your support!

Rudi,

If you're interested and would provide a valid email address, I will send you my one click setup. It will install on Windows based PC's regardless of permissions and has auto-connect capability on reboot.

how bout the rest of us?

kevin@kevinhodgeDOTcom

same as rudi... replace the one DOT with .

Guest · Post by **Guest** » 2005-02-04 15:50

hi, i have a problem with FT in Sc.
i use rc19 of 17.01.05 but when i start single file trasfert , ultravnc freeze and then disconnect.
sometime there's a windows socket error too ...

layrebayre · Post by **layrebayre** » 2005-02-12 14:38

DOOFUR WROTE:

Thanks for your support!

Rudi,

If you're interested and would provide a valid email address, I will send you my one click setup. It will install on Windows based PC's regardless of permissions and has auto-connect capability on reboot

I would also be interested in that for my established clients, please send to layrebayre@hotmailDOTcom

[/b]

UltraVNC

Enabling File Xfer Mode on SC

Enabling File Xfer Mode on SC

Thanks!

Re: Thanks!

SC reconnect on reboot