OneClick Ultra Questions?

[zone97]

I have a few questions i could not find answers to when I searched the forum.

I downloaded...

ftp.erm.tu-cottbus.de/ultravnc/TEST19_13/winvnc_CLCK.exe

awhile back when it was available. And need to know if it can do the following.

Can you make this program close when disconnected. I use INNO to install. And run and connect when the setup finishes. I would like it to close the program when vnc disconnects? Can this be done?

also does this version support file transfer? Do i need to supply other dlls or what not to make it work?

Lastly is there any support for this version? or a newer version available?

Thanks.

[ich]

Rudi is hosting a page and a build utility on his home machine (when he's online, but I understand he's getting it hosted shortly) http://gotovnc.dynalias.com/

Fully functional version that works through firewalls and is perfect for most help-desk situations, it even uninstalls itself when you disconnect.

Running a repeater and accessing it in Mode 2, I can be behind a firewall using NAT and still take control of another machine behind another firewall using NAT.